Archived Posts » 60,546,157
Bullpup build???
6/5/2012 3:20:52 PM
Yes, I know this isn't the Bullpup forum in the Armory section, however, it is about building an AR.
About 6 months ago there was someone here that was machining out their own Bullpup stock that an AR lower would fit into and they had plans to produce them. If I remember correctly it was an Asian guy that was doing it.
Does anyone remember or know what/if anything has happened on the project or know of anyone else doing a similar project??
About 6 months ago there was someone here that was machining out their own Bullpup stock that an AR lower would fit into and they had plans to produce them. If I remember correctly it was an Asian guy that was doing it.
Does anyone remember or know what/if anything has happened on the project or know of anyone else doing a similar project??
6/5/2012 4:07:01 PM
6/5/2012 4:19:37 PM
Originally Posted By idonutn0:
Yes, I know this isn't the Bullpup forum in the Armory section, however, it is about building an AR.
About 6 months ago there was someone here that was machining out their own Bullpup stock that an AR lower would fit into and they had plans to produce them. If I remember correctly it was an Asian guy that was doing it.
Does anyone remember or know what/if anything has happened on the project or know of anyone else doing a similar project??
Yes, I know this isn't the Bullpup forum in the Armory section, however, it is about building an AR.
About 6 months ago there was someone here that was machining out their own Bullpup stock that an AR lower would fit into and they had plans to produce them. If I remember correctly it was an Asian guy that was doing it.
Does anyone remember or know what/if anything has happened on the project or know of anyone else doing a similar project??
Here you go.
http://www.ar15.com/forums/t_3_4/500425_I_m_Building_a_PDR____ETA__CHIPS_ARE_FLYING__pg8.html
