Archived Posts » 59,726,163
PSL scope mount question
12/18/2011 7:22:56 PM
New to the PSL line,I picked up a romy scope for mine.
Question is:How far is the scope suppose to mount on the rail?
It goes about half way, and gets stuck, with some of the rail still showing above the mag.
A pic would be great.
Thanks in advance.
Question is:How far is the scope suppose to mount on the rail?
It goes about half way, and gets stuck, with some of the rail still showing above the mag.
A pic would be great.
Thanks in advance.
12/18/2011 7:57:18 PM
Originally Posted By 762x39nut:
New to the PSL line,I picked up a romy scope for mine.
Question is:How far is the scope suppose to mount on the rail?
It goes about half way, and gets stuck, with some of the rail still showing above the mag.
A pic would be great.
Thanks in advance.
New to the PSL line,I picked up a romy scope for mine.
Question is:How far is the scope suppose to mount on the rail?
It goes about half way, and gets stuck, with some of the rail still showing above the mag.
A pic would be great.
Thanks in advance.
It goes all the way on to the mount.
12/18/2011 8:01:00 PM
You might have to loosen the castle nut on the lever if it's too tight to move foward.
12/20/2011 6:02:43 AM
There is a block, that is on the lever shaft between the nut and spring.It is sitting in the way of the rail keeping the scope from sliding all the way on.I'll have to fiqure out a way to get that off.
12/20/2011 10:33:42 AM
Originally Posted By 762x39nut:
There is a block, that is on the lever shaft between the nut and spring.It is sitting in the way of the rail keeping the scope from sliding all the way on.I'll have to fiqure out a way to get that off.
There is a block, that is on the lever shaft between the nut and spring.It is sitting in the way of the rail keeping the scope from sliding all the way on.I'll have to fiqure out a way to get that off.
Post a picture before you change shit around.
12/20/2011 1:07:11 PM
Perhaps this will help clarify things a little. Although these instructions are for a different mount, the procedure is the same.
12/20/2011 6:59:12 PM
Got it done.The block was stuck, not allowing the mount to slide all the way on.
Thanks for the drawing, and all your input.
Thanks for the drawing, and all your input.
12/21/2011 10:30:07 PM
Ive got the same question. Thanks for the diagram. My mount, BP02, has a notch at the end of it, and I assume it is supposed to go into the indentation at the very end of it? Sorry if I hijacked this thread.
12/23/2011 10:39:15 PM
Originally Posted By euroross:
Ive got the same question. Thanks for the diagram. My mount, BP02, has a notch at the end of it, and I assume it is supposed to go into the indentation at the very end of it? Sorry if I hijacked this thread.
Ive got the same question. Thanks for the diagram. My mount, BP02, has a notch at the end of it, and I assume it is supposed to go into the indentation at the very end of it? Sorry if I hijacked this thread.
I'm sure somone will help you, like the gut who sent the KVAR pic.Which helped me.Then you get other people who are just born morons.
